I am looking for some direction on fixing my turn signal/parking lamps. I have replaced the housings which were warped and allowing moisture inside that was blowing bulbs. I have replaced the bulbs and now have the following situation.
Front right- no parking light, turn signal works, hazard works
Front left- parking light works, no turn signal, no hazard
Please advise.
Thanks
Justin
Turn signal/parking lamps
Moderators: FAOA Administrators, FAOA Moderators
Re: Turn signal/parking lamps
You may want to supply more information. Did the problems you are having in the front lights start only after you replaced the housings? Take into consideration which bulbs were blowing before, and which ones are giving you trouble now. Did the car blow bulbs when you aquired it, or did they start sometime later? Are there any modifications/splices in the wiring harness to the housings?
Possibly the turn signal switch? Wild guess only. Good luck.
Possibly the turn signal switch? Wild guess only. Good luck.
Re: Turn signal/parking lamps
Stock harness. Started having problems with condensation in the housings and blowing bulbs on both sides around the same time. Both sockets look pretty black inside and appear to have been very hot at some point. Had a problem with my switch in my GM pickup and does not appear to be the case with my Firehawk. Sockets are reasonable, so I will probably replace and report back.Mike LT4 wrote:You may want to supply more information. Did the problems you are having in the front lights start only after you replaced the housings? Take into consideration which bulbs were blowing before, and which ones are giving you trouble now. Did the car blow bulbs when you aquired it, or did they start sometime later? Are there any modifications/splices in the wiring harness to the housings?
Possibly the turn signal switch? Wild guess only. Good luck.
Thanks
Justin